991 WB Rear Splitters

These parts are designed for maximum strength and durability once installed, however incorrect handling, excessive force or torque during installation can lead to irreparable damage.
Taking your time and following the install instructions precisely will result in an easy and successful installation.

PLEASE READ ELSE DAMAGE MAY OCCUR:

1. At the 1 minute point in the install video when hooking the upper mount onto the bumper at no point should any twisting force be applied to the hook (upper mount) else irepperabae damage will occur.

2. The hook (upper mount) should be loose and rotate freely around the bumper arch as you slide the part into place. 

3. Start low on the bumper to engage the hook and then slide the part up gently until In the correct position as shown in the video. Quick jump to applicable section in video: https://youtu.be/-Q_HqOz2_UQ?t=62 

4. For Wide Body vehicles the final tightening of the screws is done in reverse order from that shown in the video.

The full install video is linked below and covers the entire process.

If you have any questions at all, please don’t hesitate to reach out to us by email at support@emc2design.com